Welcome Guest! Log in
×

Notice

The forum is in read only mode.
Due to some maintenance operations, stambia.org will be switched to read-only mode during the 13th November. It will be possible to read and download, but impossible to post on the forums or create new accounts. For any question please contact the support team.

Topic-icon Question unable to restart etl from restart point

More
16 Apr 2019 06:46 #1 by hyesane
hyesane created the topic: unable to restart etl from restart point
Hi Team,

We have set up restart point in
This attachment is hidden for guests.
Please log in or register to see it.
etl to resume elt in case it fails or stuck at some places. But even after setting setting restart point it directly goes few steps ahead to give error. Please check attached PDF for complete details with screen shots.

This message has an attachment file.
Please log in or register to see it.

More
16 Apr 2019 09:39 #2 by Thomas BLETON
Thomas BLETON replied the topic: unable to restart etl from restart point
Hello,
If i read well the PDF file (not sure because the screenshot's compression rmoved details), the step "UPDATE GV360_SHELL_RUN STATUS" is set as "Close restart point". So the restart sequence ends on this action.
All the steps have terminated without error until the "throw error" step, which is outside the Open/Close restart sequence.
So when restarting the session it will start from "throw error".
If you want to restart from a previous step then "Throw error" must be included between an Open and a Close action.